Forum: Other Pulsar Discussion

Hey guys, after recently working on my car for a day (did quite a bit Xd) i may have knocked something under my dash and now my indicators arent working. My Central locking is (its hooked to the wires coming from my stalk) and theres no problems with my hazards. We (me and my workmates)...

Hi, Recently on my N13, the low fuel light.... brake light..... and AMP light ussually either : 1. all come on at the same time then sometimes go away 2. One of them (mostly amp) begins to flicker and then stop flickering I have a full tank and the gauge shows that well. Battery is...

hey all, new member so be easy on me lol i have a n13 with the 18le motor that keeps leaking oil. the story goes like this...i took the car to the local mechanics who first told me the rocker cover was cracked and was advised to replace it, i went to u-pull-it and bought another cover and also...

Im not gonna "compare" forums guys, but when i had both a honda and a bmw, both of these cars had a forum, similar to this, only packed with a DIY thread of everything. From changing oil (most basic) to changing brake pads + sensors / installing control arm bushings. all with high-res photos. ...

Hey guys, To correspond with my SR20 Fuel Consumption Thread.. - I thought I would create the QG18DE/QG16DE/GA16DE Fuel Consumption Thread, so I and everyone here can post their own tests and experiences, with this group of motors. Just recently I did the very first test of my new N16. This...

hey guys just a quick question Where abouts is the thermostat on the housing? Is it toward the front where the radiator hose fits into the housing or is it in the middle of the housing, so id have to take off the drivebelts/timing belt and covers to get to it. any advise would be good...

Hey there just recently purchased A N13 GX Pulsar Badge as a Q :mad: Problem No.1 my master cylinder brake lines are stuck in there tight. how can i remove without rounding them completely... have only started on 2 and they are almost rounded..

Hi guys, Just after a few Australian companies that offer regrind technology on most engine camshafts. I spose what i am looking for is a mini-review of the companies too, based on previous experiences and what not. I have heard good things about CAMTECH CAMS but their specs look to be...

Hi, I have an N15 and the tacho reads correctly sometimes, and other times it will go full scale to the stop beyond 8K even though the motor is just idling, and then read random numbers. Any clues to fix? John 535is

yes i know this is my like 50000th thread the astra is having problems starting up its mostly on a cold start it will run on 3 cylinders initially for some reason and sometimes then stalls, floods it self and then is unable to start, when u get it going if u keep revving it all of a sudden...

is the only seal that can be changed in the dizzy the big oring that seals the dizzy to the cambox? is this the only spot it can leak from? or is there an internal seal in the dizzy that can be changed too or??

I've purchased a race evolution coilover kit recently with the intention of putting them in my N13. I cranked the calipers and measured external strut diameter (45mm) and internal sleeve diameter (50mm) which means I need to use 2.5mm-3mm thick o-rings (included in the kit) Is there anything I...

Possibly stupid question (you lot should be used to these from me by now) I'm installing a tacho dash cluster in my N14. The tacho signal wire into the cluster is blue/black, and Mr Haynes thinks it's the same colour into the ECU. However the wire in that location on the ECU plug is white/red, and...

Hey just a quick question. Is there any way to open up the the headlights on an N13 so you can clean them on the inside? My left headlight is quite grubby inside.

Hey guy's, Ever since i got my new exhaust the car has been dropping really low in revs when coming to a full stop so low that it stall's.. i dont know what's going on any ideas? Maby reset the ecu?

Can anybody tell me where I can get some moulded car carpet in western Sydney for my N15 Q? All the adds I see in mags etc only seem to go up to the N14 series.

has anyone tryed to fit the gti-r rear strut brace to n13 pulsar? as in the n13 thread to beat all threads it says it does but i beg to differ looks like you have to cut the parcel shelf as it sits too low or does it only fit the hatch? ...

Hey Guy My brother has a 1.6L n13 and he wants to install a pod now whats involed in doing it. Is alot of work involed installing one. Does he need to buy a adpter to fit it. How much would he be looking at I know u can get a pod filter from supercheap for $40 or something. Just...

Today when I was driving the mrs ld astra I was finding it a bit unstable in it's handling What I've determined is the car is pulling to the left if u back off from accelerating, then if u get back on the gas it pulls straight again but if u deaccelerate it quickly starts pulling to the left...

I have a '98 N15 Plus Sedan and am just wondering where I should start to get extra horsepower. I was going to get a K&N cold air intake for my first upgrade what would be the best to get?. Also what else can I start upgrading for fairly cheap?

Can someone with an N16 please list all rim and tyre size combinations that are listed on your tyre placard... Thanks

Hi guys, I searched around to try find some pictures of both the boxes, but no luck. How is a quick and easy way to tell whether an N13 box is a LSD or non LSD? Will the spin one wheel and look at the other wheel trick work in FWD cars? if so I could just use that or won't it work? Thanks.

Alrighty well yet another problem with the beloved n13.. :( Well I seem to have a coolant leak from somewhere.. not sure where exactly.. but at the moment i can't afford to get it properly fixed so i bought a bottle of radiator stop leak. Thing is it says to add the stop leak directly into...